Camera Tilt - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera

camera tilt

Moves the camera vertically.
Synopsis camera tilt{ up [<speed>] | down [<speed>] | stop | get | set}
Options up
down
speed <1 – 20>
stop
set <position>
get
Examples >camera tilt up
OK
>
Tilts the camera up at the default speed.
>camera tilt stop
OK
>
Stops the camera's vertical motion.
>camera tilt set -5 5
OK
>
Tilts the camera 5° down from level at a speed of 5.
Moves the camera up.
Moves the camera down.
Optional: Specifies the tilt speed as an integer
(1 to 20). Default speed is 10.
Stops the camera's vertical movement.
Sets the camera's absolute tilt position in
degrees, as a floating point value between
approximately -95.00 and 0.00.
If the value is out of range, the camera returns
an error message and no motion occurs. The
speed parameter may be used with the camera
tilt set command.
The camera tilt set command blocks
execution of subsequent commands until the
camera reaches the specified position.
Returns the camera's absolute tilt position in
degrees, as a floating point value.
50