Installing The Camera; Powering Up The Camera - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Installing the Camera

Be sure you have already set the camera's video resolution switch.
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in equipment
damage and will void the warranty.
1. Route the cables to the camera location.
2. Route the cables through the mount, and install the mount on the wall or attach it to the wall box. Leave
the screws loose enough to adjust the position of the mount.
3. Level the mount and tighten the mounting screws.
4. Connect the cables to the camera.
5. Place the camera on the mount.
6. Attach the camera to the mount using the ¼"-20 x .375 mounting screw supplied with the camera.
Images for illustration only; not to scale. Camera and mount details may differ.

Powering Up the Camera

Connect camera power.
The camera will run a self-test routine and move. This will take a few seconds.
When the camera is initialized and ready, video is available and the status light is blue. At this point, the
camera is ready to accept control information.
Note
Wait until the camera finishes initializing before trying to operate or control it.
11