Software-Controlled Video Output Resolution Setting; Indicator Light Behavior Settings - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Software-Controlled Video Output Resolution Setting

S , DIP S
YSTEM PAGE WITCHES TAB
Position 0 of the rotary switch on the back of the camera selects software control of the HDMI output
resolution. The default resolution is 1080p/59.94. The NDI software controls the resolution of the NDI
stream.
Set the video output resolution on the System page, General tab.

Indicator Light Behavior Settings

S , G
YSTEM PAGE ENERAL TAB
The following settings are available for the indicator light:
LED On:
Enabled (default setting) – The indicator is on when the camera is connected to power.
n
Disabled – The indicator remains off at all times. This setting overrides the LED On in Standby setting.
n
LED On in Standby:
Enabled (default setting) – The indicator remains on when the camera goes to standby (low-power)
n
mode.
Disabled – The indicator turns off when the camera is in standby mode.
n
LED Color Scheme:
Pro A/V (default setting) – Includes a tally function.
n
Unified Communications – Normally used in video conferencing installations.
n
39