Telnet Command Reference; Camera And Video Management Commands - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Telnet Command Reference

Vaddio's Telnet command protocol allows external devices
to control the camera. Network connectivity and a Telnet
client are required; Telnet port 23 is used. Telnet sessions
require the administrator account login.
In addition to the camera control commands, Telnet session
management commands are available – help, history, and
exit.
Things to know about Telnet:
By default, Telnet access is disabled in all firmware
n
releases issued after mid-December 2019. Enable it on the Security page of the web interface.
The > character is the command prompt.
n
Using a question mark as a command parameter will bring up a list of available subcommands or
n
parameters. Example:
camera focus ?
camera focus
near Focus the camera near
far Focus the camera far
stop Stop the camera focus
mode Camera focus mode
CTRL-5 clears the current serial buffer on the device.
n
Typographical conventions used in this manual:
{ x | y | z } – Choose x, y, or z. Example: camera led { on | off | toggle }
n
<variable> – Substitute the desired value here. Example: camera ccu get <param>
n
< x - y > – Valid range of values is from x through y. Example: camera ccu set detail <0 -15>
n
[parameter] – Parameter is not required. Example: camera pan left [<speed>]
n

Camera and Video Management Commands

The following camera and video management commands are available:
camera home
n
camera pan
n
camera tilt
n
camera zoom
n
camera ptz-position
n
camera focus
n
camera preset
n
camera ccu get
n
camera ccu set
n
camera led
n
camera icr
n
video mute
n
camera standby
n
49