Camera Tilt - LEGRAND VADDIO RoboSHOT 30E-M Complete Manual

camera tilt

Moves the camera vertically.
Synopsis camera tilt{ up [<speed>] | down [<speed>] | stop | get | set <position> [<speed>]
[no_wait] }
Options
up
down
speed <1 - 20>
stop
set <position>
no_wait
get
>camera tilt up
Examples
OK
>
Tilts the camera up at the default speed.
>camera tilt down 20
OK
>
Tilts the camera down at a speed of 20.
>camera tilt set -5
OK
>
Tilts the camera 5° down from level at the default speed.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
37
Moves the camera up.
Moves the camera down.
Optional: Specifies the tilt speed as an integer
(1 to 20). Default speed is 10.
Stops the camera's vertical movement.
Sets the camera's absolute tilt position in
degrees, as a floating point value between
approximately -30.00 and 90.00. This is the
minimum range; individual cameras may have
an additional degree or two of travel before
they reach their physical limits.
The camera tilt set command blocks
execution of subsequent commands until the
camera reaches the specified position.
Optional – allows the camera tilt set
command to return the command prompt
immediately, while the requested camera
movement is still in progress.
Returns the camera's absolute tilt position in
degrees, as a floating point value between
approximately -30.00 (down) and 90.00 (up).
Note that the range is roughly 30.00 to -90.00
if Image Flip is selected.