Status Light; Video Resolution Setting; About Ceiling-Mounted Cameras - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Status Light

The light in the camera's base indicates its current state.
Blue: Normal operation (blinks once when the camera receives a command from the remote)
n
Red: On-air tally (signal provided by external device via serial connection)
n
Blinking red: Video is muted (UC color scheme only)
n
Purple: In standby mode or booting
n
Yellow: Firmware update in progress
n
Caution
Do not remove power or reset the camera while the indicator is yellow, showing a firmware update in
progress. Interrupting a firmware update can make the camera unusable.
Note
By default, the camera's status light is active during normal operation; however, it can be configured to
remain off when the camera is powered up. The camera may be sending video even if the indicator light is
off.

Video Resolution Setting

Set the desired video output resolution with the rotary switch before installing the camera.
Position 0 selects software control, which allows you to set the video output resolution in the web interface.
The default resolution for this setting is 1080p/59.94.
See Software-Controlled Video Output Resolution

About Ceiling-Mounted Cameras

If you use an inverted mount, you will need to use the Image Flip setting to orient the video image correctly
and set the tilt motors to respond appropriately to tilt commands from the remote, web interface, and
connected control devices. After the camera has power, this setting is available to the administrator on the
System page of the web interface, under the DIP Switches tab.
Note
If mounting this camera using the Half-Recessed Ceiling Mount, you will need to power the mount's IR
receiver separately to use the IR remote with the camera. Use Power Extension Module 999-1005-021.
This camera does not supply power to the mount's IR receiver.
Setting.
7