Manual Access And Initial Device Set-Up; Getting The Camera's Ip Address For Manual Access; If The Camera Is At 169.254.1.1; Opening The Web Interface - LEGRAND vaddio RoboFLIP 30 HDBT Complete Manual

Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera
To access the camera's web interface from the Vaddio Deployment Tool:
Select the camera's IP address from any page where it appears. The Vaddio Deployment Tool does one of
these things:
Takes you to the camera's Initial Device Setup page if no admin password has been set.
n
Prompts you to authenticate if the initial device setup has been done.
n
Logs you in to the web interface as admin if you have already authenticated.
n
If the Vaddio Deployment Tool does not find the camera:
Download the latest version of the Vaddio Deployment Tool.
n
Verify that the camera is connected to the network.
n
Be sure you are scanning the right subnet.
n
Check the camera's IP address
n

Manual Access and Initial Device Set-Up

For manual access and initial device set-up, the general process is:
1. Discover the camera's IP address.
2. Access its web interface.
3. Complete the initial device set-up.

Getting the Camera's IP Address for Manual Access

If you are not using the Vaddio Deployment Tool or a Vaddio Device Controller to access the camera's web
interface, you will need to know its IP address.
If you know that your network does not automatically assign IP addresses, skip this section: The
camera's address is 169.254.1.1. You will need to connect your computer's network port to the camera's
network port to do the initial device configuration and network configuration.
If you are not sure, or you know that your network automatically assigns IP addresses, you will
need to be able to view the camera's video output on an HDMI display.
Point the IR Remote Commander toward the camera and press the Data Screen button. The camera's IP
and MAC addresses are displayed. Press the Data Screen button again to dismiss the display.
If the address is 169.254.1.1, the camera is using its default IP address.

If the Camera Is At 169.254.1.1

This is the camera's default IP address. This means one of these things:
The camera is not connected to the network.
n
The network does not automatically assign IP addresses, and you need to configure the camera for the
n
network.
To communicate directly with the camera, connect a cable from your computer's network port to the
camera's network port. This will allow you to access the web interface.
After you have done the initial device set-up, you will need to configure the camera for the network.

Opening the Web Interface

Enter the IP address or hostname in your browser's address bar. You may need to enter https:// as a
prefix to keep the browser from treating it as a search query.
manually.
13