Manual Access And Initial Device Set-Up; About The Web Interface; Getting The Camera's Ip Address For Manual Access; If The Camera Is At 169.254.1.1 - LEGRAND VADDIO RoboSHOT 30E-M Complete Manual

Manual access and initial device set-up

If you do not use a Vaddio Device Controller or the Vaddio Deployment Tool, you will need to complete
the initial device set-up manually, which requires you to discover the device's IP address and browse to
the device's web interface.

About the web interface

The camera's web interface provides:
Admin access for system administration, maintenance, and performance/behavior configuration.
n
User access for operation, including camera controls similar to those available from the IR remote.
n
Set the user password or enable guest access for this portion of the web interface.
We have tested this product with these web browsers:
®
n Microsoft Edge
®
Chrome
n
®
Firefox
n
®
Safari
n
We test using the browser version available from the vendor at that time. Other browsers are likely to
work also.

Getting the camera's IP address for manual access

If you know that your network does not automatically assign IP addresses, skip this section: The
camera's address is 169.254.1.1. You will need to connect your computer's network port to the camera's
network port to do the initial device configuration and network configuration.
If you are not sure, or you know that your network automatically assigns IP addresses, you will need to be
able to view the camera's USB stream to get the IP address.
To get the camera's IP address:
1. Connect the camera to the network, and connect the camera's USB cable to your computer. Then
power up the camera.
2. Open a media player such as VLC Media Player and view the USB stream (If you use VLC Media
Player, this is the "Open Capture Device" option under Media.). The camera is available as a video
capture device; the device name is the camera model name.
3. Point the remote at the camera and press the Data Screen button, or press the IP button on the back
of the camera.
4. Press the button again to dismiss the information display.

If the camera is at 169.254.1.1

This is the camera's default IP address. This means one of these things:
The camera is not connected to the network.
n
The network does not automatically assign IP addresses, and you need to configure the camera for
n
the network.
To communicate directly with the camera, connect a cable from your computer's network port to the
camera's network port.
After you have done the initial device set-up, you will need to configure the camera for the network.
Complete Manual for the RoboSHOT 30E-M PTZ Camera
11