How To Prepare The Dispenser For Operation; Menu Code 3 - How To Enter And Change The Security Code - Bennett 3000 Series Operator's Manual

HOW TO PREPARE THE DISPENSER FOR OPERATION

NOTE: Connect the Mangers Keypad to the J3 connector on the CPU for the hose that you
want to program. (If this dispenser was ordered with the Local Preset option, you
will use the Local Preset Keypad). Make sure that the handle is in the off position
and that the dispenser power is on. Press the "Cancel" and "Enter" button simul-
taneously twice and hold for approximately 3 seconds until you see "Code 00" on
the display. See Figure. When you are finished programming, press the "Cancel"
and "Enter" button simultaneously to exit the Manager mode.
Note: When you are finished programming the dispenser, disconnect the keypad and cable
from the CPU and you should leave the Manager Keypad and cable inside the head
of the dispenser for the next time you need it.
How To Access Manager's Mode - Menu Code 3
Access to Menu Codes 3 through 99 is gained by entering a four-digit access code. The software is
set with an access code at the factory of 2218. All dispensers covered in this manual are shipped
with this code. Menu Code 3 must be used each time the Manager wishes to access or program
Menu Codes 4 through 99. Menu code 3 does not need to be accessed to retrieve electronic totals.
To access the Manager's Mode, follow this procedure:
1. Press the 3 button and then the MODE button on the keypad. See Fig. 1
2. The display shown in Figure 2 appears.
3. Enter the default number 2218. Four dashes appear in the display. See Figure 3.
4. Press the ENTER button. When access is gained, the four dashes disappear. If the dashes do
not move, the access code entered did not match the code stored in memory. Press the CAN
CEL button and repeat steps 1, 2, and 3.
5. When access is gained, press the CANCEL button to exit. See Figure 4.
How to Change the 4 digit Manager's Access Code
A new access code can also be assigned in Menu Code 3.
NOTE - It is highly recommended that the factory default value of 2218 be kept in program-
ming. If the security code is changed by someone and you do not know what the code is, you
will not be able to access the programming modes.
3000 Series Retail Operators Manual 108796 Rev C, 07/05
19
Code 00—Main Program-
ming Mode.
Fig. 1
Fig. 2
Fig. 3
Fig. 4