Default Programming Settings - Bennett 3000 Series Operator's Manual

The software program for each new dispenser shipped from the factory is preprogrammed with default settings in
some of the Menu Codes. Some menu codes must be changed immediately to make the dispenser operational in
your situation. See Initial Setup Sequence below. For your convenience, the default listings are noted below:
Menu Code
0 Diagnostics
1 Money and Volume Totals
3 Manager Access
4 Prices
8 Decimal Location
9 No Flow Time Out
10 Slow Flow Amount
11 Volume Allocation
12 Prestart Time
15 Fleet Option
16 Unit Volume
17 Local Preset
18 Motor Delay
21 Stand Alone
22 Dispenser Address
24 Preset Data Entry Digit Pointers
27 Meter Calibration
83 Cold Start
99 Volume Units
To program the dispensers memory for the first time, or following a RAM memory clear follow the menu codes in
the order that they appear in the "Initial Setup" sequence below. If not, the dispenser may not operate properly
because of default settings.
The menu codes are explained in the Operators Manual in numerical order.
Menu
Code No.
Manager Access Code
3
Unit of Measurement
99
Pricing
4
9 No Flow Time out
11 Volume Allocation for a sale at a pump
Current Loop, Stand Alone or RS485 mode
21
3000 Series Retail Operators Manual 108796 Rev C, 07/05
DEFAULT SETTINGS
Suggested Start Up Sequence
INITIAL SETUP
18
Description Default
2218
0000
0 = U.S.A.
- - - = Infinite Time
0.100 Volume Unit
9999 Volume Units
2 seconds
1 = Enabled
0 = Disabled
2 Seconds
Current Loop
0 = Program to set the dispenser address.
Off
0.00
Program to set the dispenser at gallon or liter operation.
Menu
REMAINING DISPENSER SETUP
Code No.
8 Decimal Location - for other than U.S. standard
10 Slow Flow Amount - control for prepay sales
Precharge Time - for submerged pump
12
Fleet System - Interface compatibility
15
17 Local Preset - operation
18 Motor Delay - Self Contained Pumps
Dispenser Address
22
27 Meter Calibration—View Only