Menu Code 83 - How To Perform A Cold Start - Bennett 3000 Series Operator's Manual

How to Perform a Cold Start on the Dispenser Menu Code 83
This menu code allows the manager or operator to reset the manager modes back to the default
values. Refer to the beginning of this section to see the default settings and to see the suggested
set-up sequence. A cold start also clears some error counting logs. This does not clear dispenser
totals, or meter calibration constants. This mode also restores the security code back to the factory
default of 2218.
To perform a cold start, follow this procedure:
1. After the Manager's Mode has been accessed, press the number 8 and 3, then the MODE
button on the keypad. The display shown in Figure 2 appears.
2. Press the 1 for YES (see Figure 3) or the 2 for NO on the keypad and press the ENTER but-
ton.
NOTE: If the YES button is entered, the RAM is cleared and the dispenser re-boots. You
will see the software ID. See Figure 4. and the dispenser automatically goes to normal opera-
tion. You will notice the last sale shows all 0000's. See Figure 5. You may need to recheck
the dispenser programming since some values get reset after a RAM clear.
3. Press the CANCEL button to exit this menu.
Lost or Forgotten password - If the password has been changed and you do not know what it is,
you will need to follow these steps:
Note - This procedure requires breaking the calibration seal on the E-cal switch. Make sure to re-
seal the switch when you are done.
1. Open the upper electronics door and lower it. Locate the e-cal switch on the top of the CPU.
2. Break the seal and push the e-cal switch to the "On" position. Press "Cancel" (Clear) on the
keypad.
3. Press "3" and "Mode". Press the "Up" arrow. Enter the new pass-code. (You will see it as you
enter the numbers). Press "Enter"
4. Turn the E-cal switch back off and reseal.
3000 Series Retail Operators Manual 108796 Rev C, 07/05
35
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5