General Programming Instructions - Bennett 3000 Series Operator's Manual

4. With the Manager's keypad properly connected, on the Manager Keypad, press the
"Cancel" and "Enter" button simultaneously and hold for 3 seconds until you see "Code 00"
on the display. See Figure 2.
5. When the programming session is complete, press the "Cancel" and "Enter" button simulta-
neously to exit the Managers Mode.

General Programming Instructions

Make sure the dispenser power is on and the pump handle is in the off position prior to entering the Man-
ager (programming) mode.
The dispenser has a variety of Menu Codes that are accessed by using the manager's keypad. Menu
Codes 0 and 1 are accessed by the attendant or the manager to read diagnostic error codes or totals. The
remaining Menu Codes are used by first entering an access code in Menu Code 3. Without the correct
access code, the remaining Menu Codes are hidden. A description of each Menu Code is given below:
Menu
Code Name
0 Diagnostics
1 Hose Totals
3 Manager Access
4 Pricing
8 Decimal Location
9 No Flow Time Out
10 Slow Flow Amt
11 Volume Allocation
12 Pre-charge Time
15 Fleet Option
17 Local Preset/
18 Motor Delay
21 Stand Alone
22 Dispenser Address
24 Preset Data Entry
Pointers
27 Electronic Calibration
83 Cold Start
99 Volume Units
Please read the explanation for each menu code for complete information on these options.
Description
Diagnostic tests
Reading Money, Volume, Number of Sales, Number of Price
Changes
Entering a four digit code to access remaining Menu Codes
Program to set price per volume for each hose & one or two tier
pricing
Program to change decimal placement for other than U.S. standard
Program to set a time for the dispenser to turn off after flow stops
Program to control the slow down limit on a prepay sale
Program to control maximum volume of a single sale at one pump
Program to set the submerged pump pre-charge time
Program to set Fleet system interface compatibility
Program to set the way the Local Preset option operates & how to
select the Preset Language applicable language
Program to set when the self contained motor turns on
Program to set the dispenser in stand alone or console mode
Program to set the dispenser address
Program to define the entry point for a preset sale
Electronic Calibration setting - View Only
Cold Start the Dispenser Memory (RAM)
Program to set the volume units for the hose
3000 Series Retail Operators Manual 108796 Rev C, 07/05
17
Fig. 1 - Manager Keypad
Fig. 2