How To Program The Dispenser Using The Local Preset - Bennett 3000 Series Operator's Manual

How to Program the Dispenser Using the Local Preset

The 3000 Series electronic dispenser can be ordered with the Local Preset
option. The Local Preset is used in countries where there is an attendant at
the pump to dispense fuel for the customer. The attendant can select
"volume" (gallons or liters etc..) OR currency (dollars, pesos etc..) and pre-
set the amount of fuel for the customer. Once the dispensed amount reaches
the preset amount the sale stops. An example of what the dispenser might
look like is shown in Figure 1.
The local preset overlay is shown in Figure 2. This keypad has two func-
tions:
1) To be used by the attendant during the fueling process
2) To program the dispenser
When you have a Local Preset, this keypad takes the place of the Manager
Keypad and is used to program the dispenser. The programming of the dis-
penser remains the same as with any other retail electronic dispenser. There
are no "extra" modes to program just because you have the Local Preset
option. The only difference between the Local Preset option and a standard
retail 3000 series electronic dispenser is that a couple of the programming
keys are not shown on the keypad overlay. See Figure 3.
How to Program the Dispenser Using the Local Preset -
1) Make sure that the handle for the hose position that you want to pro-
gram is hung up in the Nozzle Boot. If the handle is lifted, the hose
position cannot go into the Manager Mode.
2) On the Local Preset keypad press the "Cancel" and the "Enter" keys
simultaneously and hold until the display shows "Enter Code 00". See
Figure 4.
3) Remember, the "Mode" and "Enter" buttons are not shown (Hidden) on
the overlay, but you will be able to feel them. The "Mode button is
located to the right of the "0" key and below the "9" key. The "Enter"
button is located to the right of the "Mode" key and two spots down
from the "Volume Preset" key. Refer to Figure 3.
4) Once you are in the Manager Mode, you can program the dispenser as
you normally would. To exit the Manager Mode, press and hold the
"Cancel" and "Enter" buttons together until the display returns to the
normal sales display.
3000 Series Retail Operators Manual 108796 Rev C, 07/05
39
Figure 1 - Local Preset option uses Local
Preset Keypad/Overlay for each hose.
Figure 2 - Local Preset Keypad Overlay - Used by
the attendant to pump fuel by pre-setting the cur-
rency or volume amount.
Cancel
Figure 4 - Getting into the Manager Mode -
Press the "Cancel" and "Enter" buttons to-
gether to get in and out of the Manager
Mode.
Zero "Mode" Button(Hidden)
Figure 3 - Button Functions
Money Preset
Volume Preset
"Enter" Button
(Hidden)