Bennett 3000 Series Operator's Manual page 20

How To change the Security Code - Menu Code 3
After getting past security in mode 3 you can change the security code to any 4 digit number. You can-
not disable the security code. Even if you enter all 0000's in mode 3 you would have to enter all 0000's
in mode 3 to continue.
To change the security code you must enter the current security code in mode 3. Only then can you
change it. So, after you enter the security code press "Cancel" and then follow these steps:
1. At the "Code 00" screen, press "3" and then "Mode". The display should look like Figure 1.
2. Press the "Up Arrow" button on the Managers keypad. The price window should show the what
you see in Figure 2.
3. Enter the new security code. You will notice that you can now see the number in the display win-
dow. In this example we entered "2218". Make sure to press the "Enter" button after the security
code has been chosen. See Figure 3.
NOTE - It is highly recommended that you leave the security code programmed with the factory
setting of 2218. If the security code is changed and you do not know what it is, a RAM clear will
be required to get the system back to 2218.
Lost or Forgotten password - If the password has been changed and you do not know what it is, you
will need to follow these steps:
Note - This procedure requires breaking the calibration seal on the E-cal switch. Make sure to re-seal
the switch when you are done.
1. Open the upper electronics door and lower it. Locate the e-cal switch on the top of the CPU.
2. Break the seal and push the e-cal switch to the "On" position. Press "Cancel" (Clear) on the key-
pad.
3. Press "3" and "Mode". Press the "Up" arrow. Enter the new pass-code. (You will see it as you enter
the numbers). Press "Enter"
4. Turn the E-cal switch back off and reseal.
3000 Series Retail Operators Manual 108796 Rev C, 07/05
20
Fig. 1
Fig. 2
Fig. 3