Connecting The Manager's Keypad For Dispenser Programming - Bennett 2k Series Operator's Manual

Connecting the Manager's keypad for dispenser programming.

To enable the dispenser for programming:
1. Remove the keypad from the plastic bag located on the inside of
the electronic enclosure.
2. Locate the plug for the keypad (J1) located on the Display Board ,
which is located on the backside of side 1 electronic door. The plug
is located on the right side of the Display Board (see figure C.1).
3. Plug the keypad into the plug observing the plug polarity. When the
keypad is properly connected to the dispenser press [+/-] and
[Enter] simultaneously for two seconds and the dispenser will enter
the Manager's Mode. The dispenser's display will read "Enter side
1".
4. When the programming session is complete, press [+/-] and [Enter]
simultaneously, until the display returns to the last transaction.
Remove the keypad from the plug and restore the keypad to its
holder for future programming sessions.
NOTE: The keypad must be plugged into Side 1 of the
Dispenser. Plugging the keypad into Side 2 will not gain
access to Manager's Mode.
NOTE: All nozzles must be hung up in their boots prior to
programming.
dispenser is lifted then access to Manager's Mode will be
restricted.
NOTE: If the [+/-] and [Enter] buttons are not pressed prior to
unplugging the Manager's Keypad then the dispenser will
remain in programming.
127192 Rev A
How to Operate
If any nozzle from either side of the
10
Figure C.1 - Keypad Receptacle
01-26-15