How To Operate The Dispenser; How To Dispense Fuel; How To Dispense Fuel With The Local Preset Option - Bennett 4000 Series Operator's Manual

Remote and self contained dispensers with 819 and 619 electronics
Table of Contents

Advertisement

Bennett 4k Series Operators Manual
The explanations given in the menus listed in this section are intended for use by the operator, manager, or service
technician.

How to Dispense Fuel

Note:
If the dispenser stops during the delivery of fuel, check the display for an error code. If one is present, refer
Diagnostics
section.
Note:
Be sure the pump is authorized by the console or is in stand-alone mode.
To dispense fuel, follow this procedure:
1.
Remove the nozzle from the holder.
2.
Lift the handle to the on position
3.
Wait for the displays to go to all 8's and then all 0's.
4.
Squeeze the nozzle trigger to dispense fuel into the vehicle or approved container.
5.
Release the nozzle trigger when the desired amount of fuel has been dispensed.
6.
Lower the handle to the off position.
7.
Put the nozzle in the holder.

How to Dispense Fuel with the Local Preset Option

Note:
If the dispenser stops during the delivery of fuel, check the display for an error code. If an error code is
present, refer to the
Note:
Be sure the pump is authorized by the console or is in stand-alone mode.
Note:
If an error is discovered at this point, the preset amount can be changed before the flow of fuel. The preset
amount cannot be changed once flow begins.
To dispense fuel, follow this procedure:
1.
Press the Money button to change to money preset or the Volume button to
change to volume preset as shown in Figure B.2.
2.
Using the zero through nine buttons on the preset keypad, enter an amount. If
an error is made, press the Cancel button and start over.
3.
Remove the nozzle from the holder.
4.
Lift the handle to the on position.
5.
Squeeze the nozzle trigger to dispense fuel into the vehicle or approved
container.
6.
Release the nozzle trigger when the dispenser stops the flow of fuel.
7.
Lower the handle to the off position.
8.
Put the nozzle in the holder.

How to Operate the Dispenser

Diagnostics
section.
7
How to Operate the Dispenser
Figure B.1 - Lift Lever
Money
Figure B.2 – Preset Keypad
Volume

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents