Operation; Setting Welding Parameters For Standard Welding Operation - Soyer BMH-22i Operating Instructions Manual

6 Operation

NOTE
The applicable accident prevention and safety regulations have to be complied with
when operating the stud welder.
6.1.1

Setting welding parameters for standard welding operation

• Turn on/off switch to the "I" position to switch the stud welder on.
The stud welder carries out a self test. After the self test has been carried out successfully, the display
shows the setting last used.
• Set the necessary parameters for your welding task. For doing so, please refer to the standard
values indicated in the table "Welding parameters".
6.1.1.1 PG (program)
Press function key "arrow right" to set the welding program identification character "PG".
"PG" is represented blinking in the display.
An upward setting of the welding programs 1 - 30 is possible when pressing function key "arrow up".
A downward setting of the welding programs 1 - 30 is possible when pressing function key "arrow
down".
6.1.1.2 MC (main current in ampere)
• Select function "MC" by pressing either function key "arrow left" (3) or "arrow right" (4).
• Now choose an appropriate value between 300 and 2000 ampere by pressing function key "arrow
up" (1) or "arrow down" (2).
36
BMH-22i