Safety Information With Automatic Operation - Soyer HesoMatic-9 Operating Instructions Manual

7.1

Safety information with automatic operation

Risk due to accelerated welding studs
The welding studs are transported using compressed air and are therefore greatly
accelerated.

Always ensure that the stud feed hose is intact.

Each time, before you start the system, check that the stud feed hose is
correctly inserted on both sides, into the feeding unit (feeder) and the gun.

Only use stud feed hoses from Soyer GmbH.

Never bridge the safety pressure switch at the cover hood (do not trigger the
switch if the protective hood has been removed).

Do not carry out a functional check when the cover hood is opened and the
compressed air is connected.

Regularly check that the safety interlock at the stud feed hose connection piece
moves smoothly.

Only ever use system parts which are coordinated with the stud diameter being
transported (see chapter 7.3 "Converting the feeding unit" on page 34).
Stud feed malfunctions due to misalignment
In the feeder, a few screws are marked red (see the
example on the right). If these screws become loose,
the feeder must be realigned by factory.

Operating instructions HesoMatic-9 | Heinz Soyer Bolzenschweißtechnik
Do not loosen these screws.
31