Power Supply; Adjustment Of Operation Modes; Starting The Stud Welder; Operation Modes / Parameters - Soyer BMH-22i Operating Instructions Manual

BMH-22i
5.2.4

Power supply

• Compare the power data (supply voltage / current consumption) on the type plate with the data
(supply voltage / fuse protection) of your power supply network.

Always ensure the correct supply voltage in accordance with the type plate. Never
connect the stud welding device to a power supply network with incorrect supply
voltage.
• Connect mains cable to power supply using the CEE plug:
DANGER
Only connect stud welder to approved CEE sockets.
Standard connection = 3 x 400 V + protective earth conductor, 63A-CEE. If need be,
have an expert in electrics check if the socket is earthed.
5.3

Adjustment of operation modes

5.3.1

Starting the stud welder

After switching the stud welder on, the 8 LED lamps light up for a short period. The stud welder carries
out a self test which is shown on the LED display.
The stud welder is locked during the self test and it is impossible to operate it or to enter data.
After the self test has been carried out successfully, the stud welder automatically sets the parameters
which were last set.
5.3.2

Operation modes / parameters

Press the function key "arrow right" or "arrow left" (3 or 4) to select the parameters. Only the
parameter designation which is flashing on the display can be set by means of the function keys (1 or
2).
The different operation modes possible have already been briefly described.
27