Adjusting The Speed Of Immersion (Damping) For Ph-2L - Soyer BMH-22i Operating Instructions Manual

2.5.2

Adjusting the speed of immersion (damping) for PH-2L

The PH-2L stud welding gun can only be set to "Damping ON" or "Damping OFF".
An infinite adjustment of the immersion speed is not possible.
1
2
1 Setting screw
2 Securing screw
3 Hexagon screwdriver 4mm
Damping "ON"
 Loosen the securing screw (2) by turning to the left.
Manually turn the setting screw (1) to the right till stop. Use a hexagon screwdriver

of 4mm to loosen tight setting screws.
Secure the setting by turning the securing screw (2) to the right.

Damping "OFF"
 Loosen the securing screw (2) by turning to the left.
 Manually turn the setting screw (1) approx. four rotations to the left. Use a
hexagon screwdriver of 4mm to loosen tight setting screws.
Secure the setting by turning the securing screw (2) to the right.

Appendix A /10
Appendix A / Adjustment of short-cycle drawn arc stud welding guns
3
1