Appendix A / Adjustment of drawn arc and short-cycle drawn arc stud welding guns
3 Start-up
3.1
Total view
The illustration below shows the standard stud welding gun for drawn arc operation. A
large range of equipment is available.
1 Ceramic ferrule
2 Stud holder
3 Support retainer
4 Adjusting cap
5 Setting mark
6 Allen screw
7 Setting screw for damping system
8 Support leg
9 Welding cable
R
3.2
Connecting stud welding gun to stud welder
Use the gun cable and control cable to connect the stud welding gun to the stud
welder.
• Insert connector of stud welding gun's welding cable into the welding cable socket of
the stud welder.
• Insert connector of welding gun's control cable into the control cable socket of the
stud welder.
• Insert gas supply connector of stud welding gun into the relevant socket of the
stud welder (only when using "Gas" option).
Appendix A /11