Operation; Brief Description - Soyer BMH-30i Operating Instructions Manual

6 Operation

6.1

Brief description

This section is designed to provide you with a quick start into the welding operation. For detailed
information, please refer to chapter 6.2.
NOTE
The welding areas must be metallically bright.
→ If necessary, grind the area to be welded.

Switch on mains switch.
NOTE
After switching the welding equipment on, all eight LED lamps light up for a short period.
Depending on the respective operating state, further messages are shown via the digital
display.

Set operating mode "Lift test" and check the welding gun's height of lift.
NOTE
The height of lift is the distance for which the stud is lifted from the workpiece during the
welding process. This distance is required for igniting the arc.
The height of lift should amount to approx. 2 mm.

Set desired operating mode "OP" or "MEAS" (OPTION).

Choose welding parameter depending on stud diameter using the function keys.

Position welding gun with weld stud on the workpiece. When earth connection is made and the
stud in the gun touches the workpiece, the LED "Stud on Workpiece" (SOW) lights up.

Press the push button. The LED "Release" lights up and the stud welding process is started.
During the welding process, keep the gun steady. After completion of the welding process, remove
gun vertically from the welded stud to prevent widening and damaging of the stud chuck. In case of
automatic operation, a weld stud will be reloaded.
NOTE
The applicable accident prevention and safety regulations in chapter 1
have to be complied with when operating the stud welder.
39