Adjusting The Height Of Lift - Soyer BMH-22i Operating Instructions Manual

2.4.2

Adjusting the height of lift

The height of lift can be adjusted by turning the adjusting cap (2) at the welding gun's
back to the left or to the right.
Turning the adjusting cap (2) to the left increases the height of lift, turning to the right
decreases the height of lift. Turning the adjusting cap (2) by one graduation mark
corresponds to a height adjustment of approx. 0.5 mm.
After setting, check the height of lift and correct if necessary.
Appendix A /8
Appendix A / Adjustment of short-cycle drawn arc stud welding guns