Installation Of Stud Holder Into Stud Welding Gun - Soyer BMH-22i Operating Instructions Manual

2.2

Installation of stud holder into stud welding gun

Switch off the welding equipment before adjusting it (mains switch must be in "OFF"
position).
The stud holder suitable for the corresponding stud diameter is installed as follows:
Illustration: PH-5L stud welding gun
1 Support leg
• Loosen both Allen screws (2).
• Shift support legs (1) to the front till there is enough space available to install the stud
holder.
• If necessary, unscrew existing stud holder.
• Screw on and tighten appropriate stud holder.
Appendix A /4
Appendix A / Adjustment of short-cycle drawn arc stud welding guns
DANGER
2 Allen screws
NOTE
Check after installation that the stud holder is tightly screwed. There is a risk
of scorching during the welding process when the stud holder is screwed to
loosely.