Welding Operation With Shielding Gas - Soyer BMH-22i Operating Instructions Manual

Important information for standard welding operation (stud welding)
The measures mentioned in the "Start-up of stud welder" chapter have already been performed.
NOTE
The applicable accident prevention and safety regulations must be complied with when
operating the stud welder.
DANGER
Persons with pacemakers must not operate the stud welding equipment. They must not
stay in the vicinity of the stud welder being operated.
DANGER
Never touch stud or stud holder during the welding process. These components are
current-carrying!
• Position the welding gun or welding head on the workpiece and actuate the trigger. The welding
process will be started with the parameters set. The LED "Final contact" indicates the end of the
welding process.
• Do not move the welding gun or welding head during welding. Wait until the welding
process has been completed before removing the welding gun or head vertically from the welded
stud. For further information, please also refer to the operating instructions of your welding gun or
welding head.
• After completion of the welding process, the welding gun or welding head should be held in position
for about 5 seconds to allow solidification of the molten metal.
6.2

Welding operation with shielding gas

The measures mentioned in the "Start-up of stud welder" chapter have already been performed.
NOTE
The applicable accident prevention and safety regulations must be complied with when
operating the stud welder.
40
BMH-22i