Network Settings - Extron electronics SSP 200 User Manual

Network Settings

The Network Settings panel shows the current network settings for the SSP 200 (see
figure 63
Settings dialog box (see figure 66).
Figure 66.
To configure the settings for use with DHCP:
1. Set the DHCP slider (
2. Click SAVE (
IT administrator for more information.
Click CANCEL (
To configure the settings with a static IP address:
1. Ensure the DHCP slider (
1. In the IP Address field (
2. In the Subnet field (
3. In the Gateway field (
4. Click SAVE (
making any changes.
NOTE: The default TCP/IP settings are:
IP address = 192.168.254.254
•
Subnet Mask = 255.255.0.0
•
• Default Gateway = 0.0.0.0
on page 81). To change the settings, click EDIT to access the Network
Network Settings Dialog Box
) to On.
1
). An IP address is automatically assigned to the device. Contact your
5
) to exit the process without making any changes.
6
) is set to Off.
1
), enter an IP address for the device.
2
), enter the subnet mask for the device.
3
), enter the default gateway to be used.
4
) to apply the changes, or click CANCEL (
5
) to exit the process without
6
SSP 200 • Internal Web Page 83