Extron electronics SSP 200 User Manual page 64

Communication Settings
Click the Edit Communication Settings button (see figure 47,
the Hardware Settings panel to open the Communication Settings dialog box.
The Communication Settings dialog box (see figure 51) allows you to view and adjust
device settings for RS‑232 and Ethernet connections.
Figure 51. Communication Settings
If you do not want to implement any changes, click Cancel (
Settings panel or click the Go To Hardware Settings button (
Hardware Settings panel.
The Use DHCP check box (
and obtain an IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the
network is DHCP capable). Contact the local system administrator to determine if this is the
appropriate selection. Click the Apply button (
The device MAC address (
6
To configure the Ethernet settings for use with DHCP:
1.
Select the Use DHCP checkbox (
2. Click the Apply button (
To configure the Ethernet settings with a static IP address:
1. Ensure the Use DHCP checkbox (
In the IP Address field (
2.
3. In the Subnet Mask field (
4. In the Default Gateway field (
In the DNS Server field (
5.
6. Click the Apply button (
To cancel changes, at any time, click the Cancel button (
settings.
) directs the SSP 200 to ignore any entered IP addresses
1
) to make changes take affect.
8
) is also displayed on this panel though it cannot be changed.
).
1
).
8
) is not selected.
1
), enter an IP address.
2
), enter the subnet mask if required.
3
), enter the default gateway if required.
4
), enter a DNS server name if required.
5
).
8
SSP 200 • Product Configuration Software
, on page 53) on
6
) to return to the General
9
) to return to the
6
) to keep the last saved
9
56