Securing An Hdmi Connector - Extron electronics SSP 200 User Manual

Surround sound processor

Hide thumbs Also See for SSP 200:

Table of Contents

Securing an HDMI Connector

Follow these instructions to secure the HMDI connectors to the processor with the LockIt

HDMI lacing bracket provided:

Plug the HDMI cable into the processor rear

panel connection.

Loosen the HDMI connection mounting screw

from the panel enough to allow the LockIt lacing

bracket to be placed over it. The screw does

not have to be removed.

Place the LockIt lacing bracket on the screw

and against the HDMI connector, then tighten

the screw to secure the bracket.

ATTENTION:

• Do not overtighten the HDMI

connector mounting screw. The

shield it fastens to is very thin and

can easily be stripped.

• Ne serrez pas trop la vis de montage

du connecteur HDMI. Le blindage

auquel elle est attachée est très fin

et peut facilement être dénudé.

Loosely place the included tie wrap around the

HDMI connector and the LockIt lacing bracket

as shown.

While holding the connector securely against the lacing bracket, tighten the tie wrap,

then remove any excess length.

2 2 2

1 1 1

3 3 3

4 4 4

5 5 5

SSP 200 • Panel Features

Table of Contents

Do you have a question about the SSP 200 and is the answer not in the manual?