Table of Contents
Advertisement
Front Panel Features
Figure 10.
A
B
C
A
B
Source Format
C
SOURCE
PCM
CONFIG
2-CH
e
A A A
B B B
C C C
SSP 200 Front Panel Features
Status LED
Configuration port
INPUTS
Input Source format indicators
Status LED — This LED indicates the current power and boot status of the SSP 200.
Configuration port — The SSP 200 can be configured via PCS or by using Extron
1
THRU
50-60 Hz
Simple Instruction Set (SIS) commands via this USB mini‑B port or via the LAN and
RS‑232 ports on the rear panel (see
A A A
page 62). In addition, this configuration port is used for firmware updates from a PC.
NOTE: The front panel configuration port, the rear panel RS‑232 port, and the rear
panel LAN port can all be used at the same time. No connection has precedence.
The SSP 200 responds to commands in the order received.
Input Source format indicators — The bank of eight LEDs identify the format of the
audio input (see
Source Formats
•
: Dolby source material
•
DTS: DTS source material
•
PCM: 2‑channel uncompressed digital source format up to 7.1 multi‑channel
NOTES:
• A digital signal that does not have a supported sampling rate or is
compressed PCM is considered an unrecognized signal and is muted.
• When a media player is paused during playback, the SSP 200 may or
may not continue to receive source format information from the player.
Some players continue to send the same source format information in a
loop, allowing the SSP 200 to retain the previous settings. Other players
completely disconnect the signal from the SSP 200 (unlocked state) so that
the active input appears as if there is no connection present. The remainder
of players change the source output to PCM without an actual signal being
sent (digital silence). During digital silence, the PCM LED lights but the
2‑CH source LED does not.
INPUT
1
2
3
ATMOS
HDCP
EXP
D D D
Input Selections
D
Volume Adjustment
E
L
R
1(LF)
2(RF)
3(C)
4(SUB)
5
2
3
4
DMP EXP
SIS Configuration and Control
B B B
C C C
starting on page 24).
VOLUME
4
5
SSP 200
SURROUND SOUND PROCESSOR
E E E
H H H
5(LS)
6(RS)
7
8
9
(MIX)
10
RESET
RS-232
Tx Rx G
LAN
SSP 200
starting on
D D D
E E E F F F G G G
SSP 200 • Panel Features
11
Advertisement
Table of Contents
