Table of Contents
Advertisement
•
2-Channel (2-CH):
•
•
•
SOURCE
•
D
DTS
•
PCM
•
DTS:X: DTS:X source material (HDMI only)
2-CH
•
HDCP: HDMI source material (HDMI only)
•
EXP: Valid EXP connection. Blinks when the assigned EXP input is selected.
Input Selection
1
Figure 11.
Input selection buttons — Push one of the buttons to select between the five audio
D
inputs. When a button is selected, the button lights green indicating it is the active input.
For digital inputs 1 through 4, the button turns amber when it is selected and the digital
VOLUME
clock signal has not been detected.
The Input 5 button turns red when the analog input is clipping. The
Level
The SSP accepts four digital inputs and one analog input (see
on page 6):
•
Input 1 accepts digital signals through an HDMI cable.
•
Input 2 accepts digital signals through a S/PDIF coaxial cable.
•
Inputs 3 and 4 accepts digital signals through S/PDIF optical cables. The SSP 200
supports TOSLINK or TOSLINK‑compatible optical connectors that conform to
IEC‑958, S/PDIF standards.
INPUTS
All four digital inputs accept 16‑ to 24‑bit PCM audio at 32 kHz, 44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz, and 192 kHz sample rates. They support Dolby Digital and DTS
source formats.
•
Input 5 accepts a balanced or unbalanced analog input through a 6‑pin captive
screw connector. The unit can be configured to accept:
•
•
1
The input can also be selected using PCS (see
page 29) and SIS commands (see
1(LF)
Any source coming through analog input 5.
If a 2‑Channel PCM digital signal is present on any of the digital inputs, both the
PCM and the 2‑CH LEDs light.
If a Dolby Digital 2/0 or Dolby Digital 2/0 Surround source is present, both the
and the 2‑CH LEDs light.
If a DTS 2‑Channel source format is present, both the DTS and 2‑CH LEDs
ATMOS
light.
DTS: X
ATMOS: Dolby Atmos source material
HDCP
EXP
INPUT
2
3
SSP 200 Input Selection Switches
can be adjusted with the volume adjustment knob (see page 13).
L
5
A stereo signal
A mono signal (see
Listening Mode Options
THRU
2(RF)
3(C)
4(SUB)
4
5
R
on page 27)
2
3
4
Product Configuration Software
SIS Configuration and Control
SSP 200 • Panel Features
5(LS)
6(RS)
7
8
Analog Input Gain
Rear Panel Features
on
on page 62).
12
9
(MIX)
10
Advertisement
Table of Contents
