Table of Contents
Advertisement
im Vertrieb von
Installation and Operation
Installation Overview
Installation and service must be performed by authorized
CAUTION
personnel only. UL Listed electrical boxes are
recommended. See UL Requirements in this chapter.
To install and set up a CIA111, CIA114, or CIA114F5 interface, follow
these steps:
Turn all of the equipment off. Make sure that the
1
computer, the interface, and the output devices (projector/
monitor, speakers) are all turned off and disconnected
from the power source.
If applicable, prepare the site (refer to the appropriate
2
section later in this chapter for information on your
specific situation).
Attach the cables. See Front panel features and cabling and
3
Side panel features and cabling in this chapter.
Set the rear panel DIP switches. Use the Side panel features
4
and cabling section of this chapter as a guide.
Connect power cords and turn on the projector/monitor
5
and audio device, the interface, and the computer.
The picture should now appear, and sound should be
6
audible. If not, ensure that all devices are plugged in and
receiving power. Check the cabling and the DIP switch
settings, and make adjustments as needed.
Disconnect power from all the devices.
7
Mount the interface into the wall or floor box (refer to the
8
section later in this chapter that addresses your specific
requirements). If optional MAAP devices are being
installed (CIA111 only), see Mounting the optional MAAP
device(s) in this chapter.
Restore power to the devices.
9
www.camboard.de
2-2
CIA111 and CIA114 • Installation and Operation
CAMBOARD Electronics
Front Panel Features and Cabling
Tel. 07131 911201
Fax 07131 911203
2
1
IMAGE SHIFT
NO MONITOR
MONITOR OUTPUT
3
COMPUTER INPUT
4
AUDIO INPUT
5
CIA111
CIA111
6
7
NO
1
MONITOR
IMAGE
2
SHIFT
MONITOR
COMPUTER
OUTPUT
CIA114F5
3
Figure 2-1 — CIA111, CIA114, and CIA114F5 front panels
No Monitor (monitor emulation) button and LED — If you are
1
not using a local monitor, press this button to turn on the
monitor emulation feature. The LED lights to indicate that the
feature is on.
Image Shift button — While viewing the displayed image,
2
press this rocker button to adjust the horizontal positioning of
the image on screen. Pressing the left (lower on CIA114F5) side
of the button moves the image to the left and pressing the right
(upper on CIA114F5) side of the button moves it to the right.
Monitor Output connector — Plug a local monitor into this
3
female 15-pin HD connector.
Computer Input connector — Plug a computer video source
4
into this female 15-pin HD connector.
ce-info@camboard.de
CIA111 and CIA114 • Installation and Operation
2
1
IMAGE SHIFT
NO MONITOR
MONITOR OUTPUT
3
COMPUTER INPUT
4
AUDIO INPUT
5
CIA114
CIA114
6
CIA114F5
6
AUDIO
INPUT
INPUT
4
5
2-3
Advertisement
Table of Contents
