Falco 202
TEST FAILED
If the system fails the test, please see chapter Alarms - Trouble Shooting
or contact the nearest Siare Support Centre or any other support centres
authorised by Siare.
Press ESC to stop
•
Press ESC to not perform
the Turbine
characterization and exit
from the relevant screen.
The system will show the " Test
Aborted " message and after
some seconds will show again
the MAIN MENÚ.
Press START to begin
•
" CALIBRATION " phase.
Close the patient circuit.
•
Press START: the turbine
characterization calibration
will start.
Note. Press ESC: the calibration
stops.
If the calibration is performed
regularly the system shows the "
Test Completed " message.
The system and after some
seconds will show again the
MAIN MENÚ.
.
If the calibration gives a negative
result, the system shows the
"Test Failed " message.
3-37