Trigger Subsystem - Agilent Technologies 86121A User Manual

TRIGger Subsystem

:ABORt
Attribute Summary
Description
:INITiate:CONTinuous{?| {ON | OFF | 1 | 0}}
Attribute Summary
Description
The SCPI definition defines the TRIGger subsystem to
include ABORt, ARM, INITiate, and TRIGger com-
mands. The Agilent 86121A has no ARM or TRIGger
commands.
The commands in this subsystem have the following
command hierarchy:
:ABORt
:INITiate
:CONTinuous
[:IMMediate]
Halts the current measurement sequence and places
the instrument in the idle state.
Preset State: not affected
SCPI Compliance: standard
Command Only
If the instrument is configured for continuous measure-
ments, a new measurement sequence will begin. Other-
wise, the instrument stays in the idle state until a new
measurement is initiated.
Selects single or continuous measurement acquisition.
Non-sequential command
Preset State: on
*RST State: off
SCPI Compliance: standard
When on is specified, the instrument continuously mea-
sures the input spectrum.
TRIGger Subsystem 5-61