Table of Contents
Advertisement
5-36 CALCulate3 Subsystem
:CALCulate3:DRIFt:MAXimum[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute Summary
Description
:CALCulate3:DRIFt:MINimum[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute Summary
Description
Note
Only one STATe command can be turned on at any one time.
Attempting to turn more than one state on at a time results in a
"–221 Settings Conflict" error.
and signal-to-noise" on page 4-13
selecting measurements.
Sets the drift calculation to return the maximum power
and frequency values measured.
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
Use the CALC3:DRIF:PRES command to turn off all the
drift states before turning on this state. The
CALC3:DATA? query returns the maximum power and
frequency.
Note
Only one STATe command can be turned on at any one time.
Attempting to turn more than one state on at a time results in a
"–221 Settings Conflict" error.
and signal-to-noise" on page 4-13
selecting measurements.
Sets the drift calculation to return the minimum power
and frequency values measured.
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
Use the CALC3:DRIF:PRES command to turn off all the
drift states before turning on this state. The
CALC3:DATA? query returns the minimum power or
frequency.
Refer to "Measure delta, drift,
for additional information on
Refer to "Measure delta, drift,
for additional information on
Advertisement
Table of Contents
