Table of Contents
Advertisement
Table 4-7. Programming Commands (4 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
:DISPlay:MARKer:MAXimum:NEXT
:DISPlay:MARKer:MAXimum
:PREVious
:DISPlay:MARKer:MAXimum:RIGHt
:DISPlay[:WINDow]:GRAPhics
:STATe
HCOPy Subsystem
:HCOPy:DESTination
:HCOPy:IMMediate
MMEMory Subsystem
:MMEMory:STORe
SENSe Subsystem
:SENSe:CORRection:DEVice
:SENSe:CORRection:ELEVation
:SENSe:CORRection:OFFSet
:MAGNitude
:SENSe:DATA?
STATus Subsystem
:STATus:{OPERation | QUEStionable}
:CONDition?
:STATus:{OPERation | QUEStionable}
:ENABle
:STATus:{OPERation | QUEStionable}
:EVENt?
Description
Moves the marker to the signal with the clos-
est power level just below the power level of
the signal at the current marker position.
Moves the marker to the signal with the clos-
est power level just above the power level of
the signal at the current marker position.
Moves marker to the next higher wavelength
or frequency.
Turns the instrument display of the power bars
on and off.
Selects either the external or internal printer.
Starts a printout.
Creates a new file and stores the present
data.
Configures wavelength measurements for nar-
rowband or wideband devices.
Sets the elevation value used by the instru-
ment to compensate for air dispersion.
Sets the power offset value used by the
instrument.
Queries the time domain samples of the input
signal.
Returns the value for the condition register for
the node.
Sets the enable register.
Returns the value of the event register for the
node.
Lists of Commands 4-45
Code
I
I
I
S
S
S
I
I
I
S
I
S
S
S
Advertisement
Table of Contents
