Table of Contents
Advertisement
Table 4-7. Programming Commands (2 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
CALCulate1 (CALC1) Subsystem
:CALCulate1:DATA?
:CALCulate1:TRANsform
:FREQuency:POINts?
CALCulate2 (CALC2) Subsystem
:CALCulate2:DATA?
:CALCulate2:PEXCursion
:CALCulate2:POINts?
:CALCulate2:PTHReshold
:CALCulate2:WLIMit[:STATe]
:CALCulate2:WLIMit:STARt
:FREQuency
:CALCulate2:WLIMit:STARt[:WAVe
length]
:CALCulate2:WLIMit:STOP
:FREQuency
:CALCulate2:WLIMit:STOP[:WAVe-
length]
CALCulate3 (CALC3) Subsystem
:CALCulate3:ASNR:CLEar
:CALCulate3:ASNR:COUNt
:CALCulate3:ASNR:[:STATe]
:CALCulate3:DATA?
:CALCulate3:DELTa:POWer[:STATe]
:CALCulate3:DELTa:PRESet
Description
Queries the uncorrected frequency-spectrum
data of the input signal.
Sets and queries the number of points in the
data set.
Queries the corrected frequency-spectrum
data of the input signal.
Sets the peak excursion limit.
Queries the number of points in the data set.
Sets the peak threshold limit.
Turns wavelength limiting on and off.
Sets the starting frequency for the wave-
length limit range.
Sets the starting wavelength for the wave-
length limit range.
Sets the stopping frequency for the wave-
length limit range.
Sets the stopping wavelength for the wave-
length limit range.
Resets and restarts the signal-to-noise ratio
averaging.
Sets the number of measurements to average
the signal-to-noise ratio.
Turns signal-to-noise ratio averaging mode on
and off.
Queries the data resulting from delta, drift,
and signal-to-noise measurements.
Turns the delta power measurement mode on
and off.
Turns off all delta measurement states.
Lists of Commands 4-43
Code
S
S
S
I
I
I
I
I
I
I
I
I
I
I
S
I
I
Advertisement
Table of Contents
