5-62 TRIGger Subsystem
:INITiate:IMMediate
Attribute Summary
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that
this command has the time to complete before sending any
more commands to the instrument.
Agilent 86121A to wait for non-sequential commands" on
page 4-11
for more information.
Initiates a new measurement sequence.
Non-sequential command
Preset State: none
SCPI Compliance: standard
Command Only
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that
this command has the time to complete before sending any
more commands to the instrument.
Agilent 86121A to wait for non-sequential commands" on
page 4-11
for more information.
Refer to "Always force the
Refer to "Always force the