Agilent Technologies 86121A User Manual page 74

Table 4-1. Commands for Capturing Data
Desired
Measurement
Wavelength (nm)
Frequency (THz)
Power (dBm)
Laser-Line Separation
Laser-Line Drift
Signal-to-Noise Ratio
Time-Domain Data
Corrected Frequency
Domain Data
Uncorrected Fre-
quency Domain Data
Subsystem
SYSTem
TRIGger
Table 4-1 on page 4-7
that the Agilent 86121A can perform and the associated
programming commands used to return that data. In
some cases, there is more than one method that can be
used to obtain the desired data. Refer to
"Programming Commands"
these commands.
Command to Configure
Measurement
(partial listing)
CONFigure, FETCh, READ,
and MEASure
CONFigure, FETCh, READ,
and MEASure
CONFigure, FETCh, READ,
and MEASure
CALCulate3:DELTa:REFer-
ence
CALCulate3:DRIFt:STATe
CALCulate3:ASNR:STATe
CALCulate1:TRANs-
form:FREQuency:POINts
CALCulate1:TRANs-
form:FREQuency:POINts
CALCulate1:TRANs-
form:FREQuency:POINts
Making Measurements
Purpose of Commands
Presets Agilent 86121A and queries error
messages.
Stops current measurement. Acquires new
measurement data. Also used to select single or
continuous acquisition of measurement data.
shows the kinds of measurements
for the correct syntax for
Command to Query Data
MEASure:ARRay:POWer:WAVelength?
MEASure:ARRay:POWer:FREQuency?
MEASure:ARRay:POWer?
CALCulate3:DATA?
CALCulate3:DATA?
CALCulate3:DATA?
SENSe:DATA?
CALCulate2:DATA?
CALCulate1:DATA?
4-7
Chapter 5,