Automatic Return; Temple Rest Motor Inactivation; Automatic Temple Rest Closing Inactivation - Planmeca Proline CC Technical Manual

USER SETTING
AUTOPRINT SET-
TINGS
2.3

Automatic return

2.4

Temple rest motor inactivation

2.5

Automatic temple rest closing inactivation

Technical Manual
Table 1: Special user settings
CTL
AUTO
hold for
3 seconds
CTL
hold for 3 seconds
Press the CTL-key and then press and hold for 3 seconds the return- key to change the state of
the automatic return function. The indicator light of the return key indicates whether the function
is on or off. With the automatic return on the equipment will automatically return to cassette load-
ing position after panoramic exposures and when returning from the cephalostatic mode.
CTL
hold for
4 seconds
The temple rest motor can be inactivated. Press the CTL-key and press and hold down for 4 sec-
onds the temple support key. The text HLd 0 will appear on the display. Remove the supports,
the unit can be used without them.
AUTO
hold for
4 seconds
The temple supports will automatically close when the ready key is pressed.
The automatic temple support closing can be switched off as follows: Press the auto key. The
indicator light will come on. Press and hold down the temple supports key for four seconds. The
text "hLr0" will appear briefly on the main display indicating that the automatic temple support
closing is inactivated.
To switch the automatic temple support closing on repeat the above keying sequence. The text
"hLr1" will appear briefly on the main display indicating that the automatic temple support closing
is activated.
Chapter
KEY SEQUENCE
AUTO
Planmeca Proline CC panoramic x-ray B-3
B - KEYBOARD FUNCTIONS & MODES
FOR DETAILS,
"Autoprint
READY
on page B-5
PRET
h L r 0
REFER TO
settings"