Signposts - Midas XL8 Operator's Manual

6

'Signposts'

To show you where on the XL8 Control Centre the page information refers to there are
'signposts' to guide you, of which there are two types, line drawings and symbols.
The line drawings come in two sizes and represent the layout of the control centre. The
smaller of the two merely identifies the control bay location, while the larger one shows
all of the hardware controls and can pinpoint the smallest section. However, both only
identify the actual GUI screen(s).
The symbols represent a single bay and indicate whether a diagram is an image of the
control surface or GUI. These symbols are always to the top right-hand corner of their
respective diagram.
Control surface
symbol
Small line diagram of the
control centre with relevant
bays/GUI screens highlighted
Line diagram of the control centre with relevant
control surface sections and GUI screens highlighted
Chapter 1: Introduction
GUI symbol
GUI
Control
surface
XL8 Control Centre
Operator Manual