Table of Contents
Advertisement
Auxes
Parametric EQ
freq, width and gain control knobs are used in conjunction with treble, hi-mid,
lo-mid and bass buttons in the EQ control section on the output channel strip, see "EQ
(E zone)" on page 56. These select which of the four bands the surface is controlling.
All four bands are displayed on the mix bay GUI screen, no matter what is selected; the
selected area will be highlighted.
1
buttons scroll one band at a time through
the six bands in groups of four.
2
bandwidth.
3
4
frequency.
5
shape.
6
Band selection indication LEDs. The four LEDs correspond
to the four bands (out of six) shown currently in the GUI channel
strip. As their positions are relative, the illuminated LED
indicates which band is currently active. For example, if Band 1
is active (as shown right), then the bottom LED will be
illuminated.
7
Bank of six band selection indicators. Four of the indicators
will be coloured blue to show which four out of the six bands are
currently displayed, which is either Bands 1 to 4 (as in this
example) or Bands 3 to 6.
8
GEQ button takes you to the GEQ rack; see ..........
9
Graph showing effects of parametric EQ.
XL8 Control Centre
Operator Manual
5
4
2
Band selection up
and down
width control knob adjusts signal
gain control knob adjusts signal gain.
freq control knob adjusts signal
SHAPE/MODE button selects signal
6
1
6
6
1
6
3
2
79
9
7
8
1
1
5
3
4
Advertisement
Table of Contents
