Table of Contents
Advertisement
Delay effects
Front panel
1
7
8
1
Model control knob for selecting Dig.,
Tape or BBD.
2
Time control knob for selecting time;
range is 20ms to 2s.
3
Pan control knob for panning stereo
between L (left) and R (right).
4
Level control knob for adjusting the tap
level; range is from off to +10.
5
FB control knob adjusts the amount of
negative/positive feedback applied to delay.
Controls the number of repeats. Range is from
-100% to +100%.
6
Blend control knob adjusts the feedback
blend from norm to cross.
7
Tempo control knob for adjusting the
tempo in tempo mode; range is from 30 to 240
beats per minute.
8
Tap button/switch for manually tapping
the tempo.
9
In and Out meters. Each has two rows of
15 green LEDs, one each for L (left) and R
(right).
10
IN button/switch for switching Delay
effect on/off.
11
Mix control knob for adjusting the mix
between dry (0%) wet (100%).
12
HF Damping control knob adjusts the HF
attenuation of delay repeats.
13
LF Damping control knob adjusts the LF
attenuation of delay repeats.
14
Man/Tempo switch for selecting manual
(delay times specified in ms) or tempo (delay
times specified in 1/16th bar).
XL8 Control Surface
Operator Manual
2
3
4
3
2
4
5
6
6
14
5
16
15
19
15
Lo EQ control knob adjusts the amount of
LF (low EQ) cut or boost applied to the output.
Range is -12 to +12 with 0 at top dead centre.
16
Hi EQ control knob adjusts the amount of
HF (high EQ) cut or boost applied to the
output. Range is -12 to +12 with 0 at top dead
centre.
17
Gain control knob adjusts the amount of
gain between -20 and +20, with 0 at top dead
centre.
18
Rate control knob adjusts rate of delay
modulation. Range is between 0.001 and 10
with 0.7 at top dead centre.
19
Depth control knob adjusts depth of delay
modulation. Range is 0 to 100, with 50 at top
dead centre.
255
9
10
11
12
13
17
18
Advertisement
Table of Contents
