Procedure 4-3: How To Select Operational Mode In The System Tab - AGFA Jeti Tauro H3300LED Series Operator's Manual

Procedure 4-3: How to Select Operational Mode in the System Tab

- Step 1: Go to the Operational Mode pane in the system tab
- Step 2: Depending on the kind of media used and/or other optional devices installed, you can select
different Operational Modes. Here we load manual sheet mode by clicking the Load button (
in blue in Fig.4-15)
- Step 3: A customized slot configuration can be done after selecting the Operational mode
Note: Additional Remarks
- Keep Down: "during the print cycle the bar is kept down"
- This option is available for a combination of mode and slot-type:
- E.g. Slot1 can kept down in manual/standard not in manual/continuous.
- Not applicable on tensioning – and output-bar, if media is > 8mm
- Not applicable on flattening – and pinch-bar, if media is > 15mm
- Slot Type and state: during print it is not allowed to:
- Change the slot type
- Toggle the slot up or down
- Enable/Disable: it is allowed to toggle the enable checkbox during print
- The slot is disabled if the checkbox is not checked
- The new value is used as from the next swath
- Persistency: the latest used mode together with the latest slot configuration is saved.
- After a restart these are being prepared as persisted
- If the mode is changed afterwards, the slot configuration is changed to the default for that selected mode.
- Step 4: Check if the corresponding Rolls/setbar "Slot Configuration" is installed
.
(see Fig.4-16)
- Step 5: Proceed to "Perform Nozzle Check".
Agfa Graphics
. For other modes, please refer to Chapter:
Revision 1.0
Jeti Tauro H3300LED Operator Manual
.
(see Fig.4-15)
Machine Operation.
Fig.4-15: Operational Mode Pane
outlined
Fig.4-16: Slot Configuration
Chapter 4
32