Procedure 5-4: How To Print A Job In Manual Continuous Mode - AGFA Jeti Tauro H3300LED Series Operator's Manual

Procedure: How to Print a Job in Manual Continuous Mode
- Step 1: Unload the previous mode configuration, select the manual and continuous configuration
from the system pane (see Procedure:
press the load button.
- Step 2: Select the jobs to be printed as described in Procedure:
Mode".
- Step 3: Click the start icon located in the red queue banner
drop down and load your media against the set bar.
- Step 4: Click the start printing button
pedal to start. In case of multiple copies, only use the pedal.
Important: Do not press the left pedal to enable the vacuum as it starts automatically in
continuous mode. It is still possible to select the number of copies to print.
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
"How to Activate and Use Manual Continuous
Media
(outlined in green in Fig.5-24)
Revision 1.0
"How to Print a Job in Manual
(outlined in blue in Fig.5-23)
Set bar
Fig.5-23 Set Bar Icon - Manual Continuous Mode
from the GUI or press the right foot
Fig.5-24: Start Print Button - Manual Continuous Mode
Mode" and
the set bar will
Chapter 5
52