Procedure 5-5: How to Fill the Ink System
- Step 1: Locate the ink supply system in the left rear (red) cabinet.
- Step 2: Unlock and open the Ink Supply Cabinet doors.
- Step 3: Locate the RFID tag reader
- Step 4: Check that the ink container holds an RFID tag.
- Step 5: Hold the container tag against the RFID reader. When the RFID tag is identified, the ink sys-
tem checks if:
• no other ink fill process is active
• the correct bottle of ink is used
• there is enough room in the corresponding ISS tank
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
(outlined in red in Fig. 5-33)
Revision 1.0
Fig.5-32: Ink Supply System Cabinet
Fig.5-33: Ink Supply Cabinet Door
.
Fig.5-34: Ink Container RFID Tag
Chapter 5
56