AGFA Jeti Tauro H3300LED Series Operator's Manual page 36

- Step 9 Select and load the desired operational mode. Choose between Manual and Manual
Continuous (see Procedure: "How to Select Operational Mode in the System
Note: After, for example, loading manual continuous mode, follow the procedure "Zero point calibra-
tion (Continuous Mode)" and check that it has been performed. This is to be done for each dedicated
print mode to be used. (Customer Service is responsible)
- Step 10: Print and check the nozzle test pattern for colors, white and primer
to Perform Nozzle check manual
- Step 11: Choose a job and start printing
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
mode"). Technical images are located under the filter icon.
Revision 1.0
Tab").
(see Procedure: "How
Chapter 4
28