Table of Contents
Advertisement
5.2 Self-test and Dump Mode
Please follow the steps below.
1. Please check if the media roll has installed correctly.
2. Turn off the power switch (
3. Hold on the FEED button (
4. Release the FEED button (
blinking (Any blink will do during the 5 blinks).
5. It calibrates the sensor and measures the media length and prints internal settings
then enter the dump mode.
6. Turn off / on the power to resume printer for normal printing.
Self-test
Printer will print the printer configuration after
printout can be used to check if there is any dot damage on the heater element,
printer configurations and available memory space.
Self-test printout
).
) then turn on the power switch (
) when the indicator becomes
media sensor calibration. Self-test
23
).
Self Test.....
Model name
F/W version
Firmware checksum
Printer S/N
Configuration file
System date
System time
Printed mileage (meter)
Cutting counter
and
Advertisement
Table of Contents
