Procedure 5-10: How To Power Cycle The Complete System; Procedure 5-11: How To Recover After A Power Cut During Printing; Reporting An Error - AGFA Jeti Tauro H3300LED Series Operator's Manual

Power Cycling the Complete System
Under some circumstances, (for example, connecting or disconnecting a peripheral device) the entire
system needs a complete power down. Therefore, Agfa recommends to always perform the following
procedure before calling for support.
Note: Refer to Procedure:
five steps of the following procedure.
Procedure: How to Power Cycle the Complete System
- Step 1: Turn the Jeti Tauro H3300LED modules off See Procedure: How to Switch the Engine Off for a
Short Period
- Step 4: Turn the printer mains switch OFF.
- Step 5: Restart the operating system of the GUI computer from the bottom left Windows® icon.
- Step 6: Wait for the GUI computer initialization completion.
- Step 7: Perform a normal system start up as documented in Procedure:
Start-up".
Procedure: How to Recover After a Power Cut During Printing
- Step 1: Open the operator access door.
- Step 2: Manually move the shuttle above the drip tray and avoid staining the media drive belt. The
shuttle air supply is off when the Jeti Tauro H3300LED power supply is missing and the print heads
could start dripping ink.
Danger: Take care not to touch the UV LED modules when pushing the shuttle home!
- Step 3: Turn the main switch in to the OFF position.

Reporting an Error

For a quick and efficient service:
- Contact your local point of contact
- Note and communicate to your service organization the error ID and the circumstance of the error
occurrence.
Note: Refer to
Clearing Errors
Agfa Graphics
"How to Switch the Engine Off for a Short
to identify the error code.
Revision 1.0
Jeti Tauro H3300LED Operator Manual
Period" for details about the first
"How to Perform the Daily
Chapter 5
65