AGFA Jeti Tauro H3300LED Series Operator's Manual page 66

- Step 8 Slide the ink container in the ISS inlet. When the ink supply is detected by the system, the
LED on the ISS will stop blinking.
Important: Always empty the complete bottle since, once used, the same tag cannot be ac-
cepted anymore. Thirty minutes after reading and accepting, the tag on the ink bottle will be locked
from further use.
- Step 9 Leave the bottle to drain and the system will monitor the refill. If needed, you can start the
process of refilling another color.
Caution: Use only Agfa approved inks. Using inks that are not approved by Agfa can
damage the print system. Agfa holds the right to alter the engine warranty terms
and service conditions when ink not accredited by Agfa is used in the system.
Agfa Graphics
Jeti Tauro H3300LED Operator Manual
Revision 1.0
Fig.5-38: Ink Container in ISS Inlet
Chapter 5
58