Full Automation; Introduction - AGFA Jeti Tauro H3300LED Series Operator's Manual

This chapter contains the following topics:

• Introduction

• Choosing between Single or Dual Lane
• Setting up Media to print
• Wrinkles Prevention and Removal Methods
• Select and print jobs from Asanti
Introduction
This chapter contains information and procedure Set up Full Automation on the Jeti Tauro H3300LED
printer.
Depending on the sheet size you wish to print, you can choose to set up 1,2,3 or 4 up to print
simultaneously.
For more information on how to properly connect and disconnect unloader from the engine, please refer
to the ? Operator Manual.
- Download pinsets from Asanti network
- Open the asanti client
- go to system overviev and select TP Tauro
- choose resource Pinsets in the resource pane (resource pane info see pdf: what is asanti (3.0-2018))
- import downloaded pinsets
- restart asanti to start using the pinsets
-
Set up job for Tauro Full automation
- In the Jobs window of the Client: File > New Layout Job.
- Select the Printer: Jeti Tauro.
- Enter sheet size 700 x 1000 mm.
- Open the Layout Sheets inspector info see pdf: what is asanti (3.0-2018)
- Select Horizontally: Tauro Pinsets
- choose 1up, 2up, 3up or 4up for verso choose tauro Pin-sets recto
Start using Autoloader
- Step 1: Start up Tauro H3300 LED, see tauro master manual
- Step 2: it's advised to do Nozzle check in Manual mode
- Step 3: Select full automatic loader see fig. Fig1 Load Full auto
Depending on configuraton choose by output, Manual or Unloader
Choosing unloader option Output On Table wil dissapear.
Revision 1.0
Option

Full Automation

99